Skip to main content

Local Community Church

Simple Sanctuary

Smaller local church faced with the need for a modest PA system balanced with the need to improve speech clarity for the congregation without overwhelming the architecture. The system must also often be capable of reinforcing amplified instrumentation.
A compact, monaural, centrally located array preserves the center focus (listening localization) on the lectern while full-range two-way or three-way loudspeakers provide sufficiently accurate reproduction of musical instruments.  
 
A slightly more sophisticated design might supplement this with “stereo” Left / Right matching loudspeakers for reinforcement of stereo instruments. For deep bass instrumentation a subwoofer can be placed near the platform center, or close to the musicians, to add range for 
increased low-frequency support.
 
Note: Twin side fill compact loudspeakers require separate signal processing for delay, gain, and equalization to fully integrate with the main center loudspeaker.
Option A:
One (1) V2-1296 (center) Two (2) V2-8 (L/R sides)
 
Option B:
One (1) V2-3294 (center) Two (2) V2-8 (L/R sides)
 
Option C:
One (1) IP6-1122/96 (center) Two (2) IC6-1062 (L/R sides)
 
Subwoofer Enhancement: VLF208LV, V2-212S, or IS600 family (any size)

AMPLIFIER

For maximum system performance and longevity, the loudspeakers must be properly powered to achieve the needed sound pressure level (SPL) in the listening area.  Refer to the product spec sheets for appropriate amplifier ratings.

PROCESSING AND PROTECTION

To properly process, equalize and protect the loudspeaker systems, it is recommended to use the Community dSPEC226 digital signal processor.

Some amplifiers have built-in processing which may be adequate when properly programmed. Community's suggested DSP settings can be found HERE.

All of the loudspeakers require an electronic high pass filter for protection against over-excursion from bass-heavy program material.

Loudspeaker protection on the dSPEC226:
Protection is handled by three stages of protective limiters: these include a short-term peak limiter to prevent over-excursion of drivers and to control amplifier clipping; a mid-term RMS limiter that prevents system overdrive; and a unique long-term power monitor that works to protect your loudspeakers from long-term thermal damage.  All three limiters operate interactively, providing unique driver protection, while allowing each loudspeaker’s full dynamic range to be utilized without compromise.

 

WIRING

When considering the distance between the amplifier and the loudspeaker(s), the following minimum cable gauges are suggested.

Less than 50 feet: 14 AWG
50 to 100 feet: 12 AWG
100 to 250 feet: 10 AWG

It is strongly recommended that all loudspeaker level wire be stranded, twisted and never shielded. Loudspeaker wires should not be connected to earth ground or supporting structures.

 

TECH SUPPORT

For technical and applications assistance, please contact the Community TAG Team (Technical Applications Group) at 1+(610) 876-3400 or tagteam@communitypro.com.

 

DESIGN GUIDE

To view the entire House of Worship Loudspeaker System Design Reference Guide, click HERE.